Thread: 3 CIM Drive Train Battery Draw
View Single Post
  #13   Spotlight this post!  
Unread 10-02-2014, 22:57
Brian C's Avatar
Brian C Brian C is offline
Doer of Whatever
AKA: Brian Cholerton
FRC #1468 (J-Birds)
Team Role: Mentor
  
Join Date: Jun 2001
Rookie Year: 1999
Location: Islip Terrace Long Island-NY
Posts: 325
Brian C has a brilliant futureBrian C has a brilliant futureBrian C has a brilliant futureBrian C has a brilliant futureBrian C has a brilliant futureBrian C has a brilliant futureBrian C has a brilliant futureBrian C has a brilliant futureBrian C has a brilliant futureBrian C has a brilliant futureBrian C has a brilliant future
Re: 3 CIM Drive Train Battery Draw
We ran in our 3 CIM gearboxes over the weekend. Measured with a DC clamp on ammeter the total currrent draw for all 3 motors on an unloaded transmission was 9.2 amps. The funny thing is when checked individually 1 motor was pulling 4.4 amps, the next was at 3.3 amps and the 3rd was at 1.5amps.

When the next transmission was run in we found similar readings as well. The same motor positions in both transmissions had the same basic readings inasmuch that they went from a high current draw to a lower current draw based on their mounting position. The readings only varied by a few tenths of an amp.

After checking gear lash there were no significant differences when run again. These are the AndyMark 3 CIM upgrades for the AM14U chassis..
__________________
2017 Season; Game Announcer at

SBPLI Long Island Regional