Hi,
We have AXIS M1013 camera and have been trying to get image on dashboard for a few days. We configured our camera and set the camera ip adress to 10.36.46.11. Our cRIO has 8 slots and 2 ethernet ports, but we preferred to use robot radio to connect the camera.
When we tried to run the "Camera Performance" example vi, the camera display on the front panel successfuly runs our camera and we get image on the front panel. I looked over the block diagram of this example code and noticed that there aren't any places to write the camera ip adress (10.36.46.11), but instead there is a block called build ip adress on the left. My first question is that how this example code knows my camera IP?
Secondly, I do not know much about how to integrate this code to my robot code and to get an image on dashboard. I tried the code in the attached image in begin vi but it didn't work. What did I miss and how can I run the camera ?
http://imgur.com/zyZ1elQ
Any help would be appreciated. Thanks.