[Alan Anderson]

If your camera Ethernet is wired to the D-Link router, then the cRIO code is not relevant. The Dashboard program connects to the Axis camera directly.

How did you configure the camera? If you used the configuration utility, you shouldn't have needed to specify the IP address explicitly. It would have used your team number to determine the correct address. If you didn't use the utility, the camera might not have the FRC/FRC user defined.

Did you turn on the "enable camera" control on the Dashboard? It's the small toggle button to the right of the bottom of the image panel.

I seem to remember something about having to activate the LabVIEW vision support before the image will appear. Run the LabVIEW License Manager program and see if anything shows up as not activated.