Thread: imaging tool does not see modules
View Single Post
  #1   Spotlight this post!  
Unread 16-02-2014, 19:18
nheft nheft is offline
Registered User
FTC #0533 (Psichotics)
Team Role: Engineer
  
Join Date: Jan 2006
Rookie Year: 1999
Location: Lindenhurst HS
Posts: 35
nheft is a jewel in the roughnheft is a jewel in the roughnheft is a jewel in the roughnheft is a jewel in the rough
imaging tool does not see modules
I tried re-imaging a cRIO-II with the 2014 imaging tool. The whole process runs through (takes about 30 minutes), gives me a message that the process completed successfully. After rebooting the cRIO and re-scanning I do not see any of the modules (I have one analog module, one digital module, and one pneumatics module installed).

I saw a similar problem last year. Went to another PC with the same version of the imaging tool - re-imaged the cRIO and saw the modules and all was well.

In all cases I am able to ping the cRIO from a command prompt with no problem.

Any ideas?

Thanks in advance

Neil Heft

Team 533 Advisor