Thread: imaging tool does not see modules
View Single Post
  #2   Spotlight this post!  
Unread 16-02-2014, 19:49
eddie12390's Avatar
eddie12390 eddie12390 is offline
Registered User
AKA: Eddie
FRC #3260 (SHARP)
Team Role: Programmer
  
Join Date: Jan 2011
Rookie Year: 2011
Location: Pittsburgh
Posts: 285
eddie12390 is a glorious beacon of lighteddie12390 is a glorious beacon of lighteddie12390 is a glorious beacon of lighteddie12390 is a glorious beacon of lighteddie12390 is a glorious beacon of light
Re: imaging tool does not see modules
Quote:
Originally Posted by nheft View Post
I tried re-imaging a cRIO-II with the 2014 imaging tool. The whole process runs through (takes about 30 minutes), gives me a message that the process completed successfully. After rebooting the cRIO and re-scanning I do not see any of the modules (I have one analog module, one digital module, and one pneumatics module installed).

I saw a similar problem last year. Went to another PC with the same version of the imaging tool - re-imaged the cRIO and saw the modules and all was well.

In all cases I am able to ping the cRIO from a command prompt with no problem.

Any ideas?

Thanks in advance

Neil Heft

Team 533 Advisor
Can you ensure that the cRIO is not working? As far as I know, the only time that the modules will show up is when using a 255.255.255.0 subnet mask but I could be wrong. I've seen weird bugs like that in the past but I've never had it cause any issues.