|
Re: Not able to connect to the cRio
If your code is maxing out the CPU then you will probably need to get the code to stop.
You can use the No App switch.
On an 8-slot cRIO the No App switch is on the front of the cRIO.
On a 4-slot cRIO the No App switch must be set with the cRIO Imaging Tool.
After the switch is set, the cRIO must be reset (button on the cRIO or cycle the robot power.
Then try downloading your code.
Finally, turn the No App switch off and reset your cRIO once again to start your code running.
__________________
"Rationality is our distinguishing characteristic - it's what sets us apart from the beasts." - Aristotle
|