Quote:
Originally Posted by AlexBrinister
Are you using closed-loop control? Check the forward and reverse limit switch jumpers on the Jaguars. If those are not properly set up, the Jaguar will flash steady red.
Alex Brinister
|
could u expand on that, however i dont think its the actual hardware thats the problem.
We tried inverting our drive system, so the left talons controlled the right side and the right talons the controlled the left side, we noticed it was only on the left jaguars.
so example if the talons are numbered 1,2,3,4 (1,2 = left, 3,4 = right). talon 1,2 would blink red and 3,4 are good. when inverted (1,2 = right, 3,4 = left) 3 and 4 are the ones blinking
so i have feeling that it might be the program, but i dont see anything in the code that might be ticking these red lights