|
Re: Breaking mounts of Encoders on Andymark Super Shifter
Quote:
Originally Posted by Phalanx
It's hard to tell from the photo you posted, but, it looks like you have the encoder bracket mounted inside out.
It should be mounted such that the "cut around" in the plastic bracket sits over the bearing in the gearbox, and it should be flat on the side you screw the encoder on to. Try flipping it 180 degrees along the horizontal plane.
That's the best I can make out from the photo.
|
I also think that it is mounted backwards. If those are the encoders I think they are you want to have most of the encoder sitting above the screws not below them.
__________________
It's pronounced StighPulse like HighPulse
2016 Curie Champions
2016 New York City Champions
2016 New York City Engineering Inspiration
2015 New York City Finalists
2013 New York City Champions
2012 Connecticut Chairman's
2011 Connecticut Chairman's
2010 Connecticut Chairman's
2010 New York City Champions
2008 New York City Engineering Inspiration
2007 New York City Finalists
2006 New York City Finalists
2005 New York City Chairman's
2003 New York City Champions
2002 New York City Engineering Inspiration
2001 New York City Finalists
|