|
Re: Team 811's 3D Printed Modular Control Board
What an awesome idea. I hope your team gets an award for it at a competition.
Just a couple questions.
I think the yellow layer is a base and the red pieces snap into it. Is that correct? What if you don't have a rectangular area? Is there places in the base layer to snap sections away?
Also, what is done to facilitate wiring and wire management? Red pieces with wire guides would make a great addition.
How do the components mount to the red pieces?
__________________
-= Mentor Lockport Warlocks -=- Team 1507 =-
Amateur Radio Callsign: AE2T
2015 Robot Inspector - Pittsburgh, Champs. Judge Observer - Champs
2014 Robot Inspector - Tech Valley, Fingerlakes, Buckeye, Championship
2013 Robot Inspector - Fingerlakes, Buckeye, Championship
2012 Robot Inspector - Fingerlakes, Buckeye, Championship
2012 Website Evaluator - Fingerlakes, Buckeye, Championship
2011 Robot Inspector - Fingerlakes 2011 Safety Advisor - Fingerlakes
|