[Greg McKaskle]

Here is what I found when looking at the M1013.

I logged into the camera to see if I could find the auto/hold exposure control on the M1013. I couldn't find it. I looked at a parameter report on the camera and verified it was in "auto" mode.

I modified the LV dashboard to set the exposure to hold. I looked at the parameter report and it said "hold". I rebooted the camera and the parameter report still said hold. I modified the exposure value on the camera's web page and saved, and it still said "hold" in the report.

So, I believe that the camera will still hold the calibration, but the web page will no longer let you set it to that mode, and in fact if you save the right things on the page, I could see how it may switch back to auto.

The parameters report is available on the web page as shown in the attachment. It is the Parameters List button. Search for [ImageSource.I0.Sensor]. I am running a beta version of Vision Assistant, so I'm not able to easily verify that it will set the camera to hold.

Can someone verify that this procedure works for them, or detail how you are setting the camera to hold and how you are checking whether it resets?

Greg McKaskle