My team has been trying to continute programming even after build season is over, and we are trying to set up a cRIO. We have a cRIO 1 with 8 module slots. I'm using the FRC 2014 cRIO Imaging Tool But, when I use the imaging tool the dip switches don't appear to register on the tool. All of them appear off, despite attempts to switch them on and off. Another thing, the modules do not appear in the cRIO on the right of the tool.
These are just cosmetic, so I tried to image the cRIO anyway. When I try it comes up with an error that tells me that it cannot reset the IP and that I need the IP reset Dip switch turned off. I've tried changing it on and off and there is no change.
I've made sure to follow the
cRIO Imaging Guide and followed the troubleshooting included there. I've also searched for forums and have found no problem similar to mine.
I hope I can get some pointers on what to try after this.