Thread: Simplest way to communicate Arduino to cRIO?
View Single Post
  #7   Spotlight this post!  
Unread 24-03-2014, 13:36
Mike Bortfeldt Mike Bortfeldt is offline
Registered User
FRC #1126 (& 1511)
Team Role: Mentor
  
Join Date: Oct 2004
Rookie Year: 2004
Location: Rochester, NY
Posts: 119
Mike Bortfeldt has much to be proud ofMike Bortfeldt has much to be proud ofMike Bortfeldt has much to be proud ofMike Bortfeldt has much to be proud ofMike Bortfeldt has much to be proud ofMike Bortfeldt has much to be proud ofMike Bortfeldt has much to be proud ofMike Bortfeldt has much to be proud of
Re: Simplest way to communicate Arduino to cRIO?
Fej,

There are several ways I can think of to communicate between an Arduino and the cRIO. None of which are probably as easy as you would like.

1) RS-232 - Although you may need a level shifter on the signal lines
2) Ethernet (as mentioned earlier)
3) I2C - Note that the cRIO limits the message length to 7 bytes, so you would need to split up your communication into two transactions. The cRIO must also be the Master.

Mike