Thread: Bosch Pinion
View Single Post
  #15   Spotlight this post!  
Unread 22-02-2003, 03:05
Travis Covington's Avatar Unsung FIRST Hero
Travis Covington Travis Covington is offline
Engineering Mentor
FRC #0254
Team Role: Engineer
  
Join Date: Oct 2001
Rookie Year: 1998
Location: San Jose, CA
Posts: 573
Travis Covington has a reputation beyond reputeTravis Covington has a reputation beyond reputeTravis Covington has a reputation beyond reputeTravis Covington has a reputation beyond reputeTravis Covington has a reputation beyond reputeTravis Covington has a reputation beyond reputeTravis Covington has a reputation beyond reputeTravis Covington has a reputation beyond reputeTravis Covington has a reputation beyond reputeTravis Covington has a reputation beyond reputeTravis Covington has a reputation beyond repute
Send a message via AIM to Travis Covington
what are the specifics of the gears you guys are using to press onto the drill motor?

we were trying to figure out what would be a good size to replace the metric gear that it currently has

I assume you guys are gearing these motors down to match speeds with the atwood? Something like 18/5 to gear it down? what gear tooths, pitches, and degrees did you guys use to reduce the output?

I am trying to take as many notes as possible in my free time i have now to use next year when we design our motor mounts (hoping we have the same drill motors, but for expirience none the less)

thanks alot!

TC
__________________
-Travis Covington

2008-2017 - Engineering Mentor of Team 254
2001-2008 - Engineering Mentor of Team 968
1998-2001 - Mechanical Director/Driver/Member of Team 115
Last edited by Travis Covington : 22-02-2003 at 04:23.