|
Drilling
Folks,
Seems like you are expecting a drill bit to give +/- 0.001 accuracy. I would say this is probably not the case. They way we always machined holes with that precision was to
drill a little small and then ream it to the correct size. A ream will give much better accuracy than a drill bit will.
Just my $0.02
__________________
"Put your hand on a hot stove for a minute, and it seems like an hour.
Sit with a pretty girl for an hour,
and it seems like a minute. THAT'S relativity." -Einstein
----
First Resume: (If I can remember)
2001 NJ Regional
2001 Championship
2002 NYC Regional
2003 OH Regional
2003 Championship
2004 OH Regional
2005 Finger Lakes Regional
2006 Finger Lakes Regional (yes!)
|