Quote:
Originally Posted by coolhandluke811
What I'm working on is based around the mounting of the board.
So I will probably have to wait for CAD to do what I need. Thank you though. I will try to do some work based off those pics
|
This picture from 1718's webpage should give you very close to what you need. If you look at the 4 "pockets" on the corners of the PCB, that is where 1/4-20 through holes would be in the plastic housing. The measuring tape in the picture should tell you the hole-hole spacing, which appears to be about 7.125 inches. Maybe this would give you enough for your project?
-Mike