Quote:
Originally Posted by compwiztobe
The linked inventor model to appears to match all the dimensions in the attached spec sheet, which is not super detailed. Visual inspection leaves me dubious of the proportions. Do you care to check this file with your measurements?
Also, since it looks like yours is probably more accurate, would you care to share a .step of it?
|
I suppose if I ask for feedback it's better provide CAD model and not just a picture eh? LOL
Attaching it now. I forgot to remove the heat sink I was designing (it was hidden in Creo), but that is something else that needs feedback as well
First of I wanted to mention, I wasn't following spec sheet, I was measuring actual compressor. I tried to be as exact as I can with reasonable tolerance. I used caliper for measuring.
There some discrepancies between sheet and actual measurements.
For example A states 5.94", but on actual compressor it is over 6", about 6 1/32" (my caliper maxes out at 6")
Checking PDF sheet you sent, here are my findings (actual measurements):
A=6.02"
B=2.052"
C=4.6"
D=5.545"
E=1.42"
F=1/4" (I suspect this is just different fitting)