Quote:
Originally Posted by Mark McLeod
I suspect from your photo that it is a 24v solenoid just because that's what has been offered in the KOP, but that style can be either voltage rating. The black end caps will have a voltage printed on them.
If it is a 24v solenoid, then it gets wired to two sets of pins on the Solenoid Breakout and the Solenoid Breakout must get 24v power from the empty connectors of the Power Distribution's special 24v output.
|
Yes you were right it was a 24v solenoid, but I was able to find a different 12v double solenoid in a couple of spare parts sitting around, but unfortunately due to exams and such our team will not be able to switch the solenoids out until next week this time. So I would just like to thank you for all the help you have offered.
I should be able to use the code above posted by Domenic Rodriguez correct?