[burde1jb]

I'm attempting to fix a red dot of trouble in our Teleop code. As seen in the attached picture of the code [BOTTOM RIGHT], we are using Button 3 of the controller to send the Spike Relay into the forward position (we used a numerical value of "2" because we could not pull up the Enum Constant which provides forward/reverse/on/off, but that is another section of help...).

Sending the two values through the T/F gate and onto the Relay Set, we get that little red dot which we know from past experience does not mean anything good. Any advice as to how to fix the issue would be appreciated. Thanks!