Thank you both so much!
Quote:
Originally Posted by avanboekel
There are motions constraint available for use in inventor. I don't remember exactly how to use it, but I think its in the same constraint window that you would use for a mate or flush constraint.
|
Thank you very much :) I figured it out. Its the motion tab in the constraint window. Select roataion for the type, forward for the solution, and T1/T2 for the ratio. I just had to make sure the teeth weren't occupying the same space before I did that.
Quote:
Originally Posted by s_forbes
For finding the distance between the centers of two meshing gears (in inches), you can use the following formula [...]
|
This works perfectly. Thanks!