View Single Post
  #4   Spotlight this post!  
Unread 05-07-2014, 17:31
Deke's Avatar
Deke Deke is offline
Registered User
no team (No Team)
Team Role: Engineer
 
Join Date: Dec 2013
Rookie Year: 2013
Location: Michigan
Posts: 139
Deke is a jewel in the roughDeke is a jewel in the roughDeke is a jewel in the roughDeke is a jewel in the rough
Re: pic: 2-Speed Gearbox

You may need slightly larger fillets in the pockets to allow for a bigger endmill to work around. I would think a .125" radius would be nice for at least a 1/4" endmill, but more experienced machinist could chime in on a nice cutter size. The larger fillets will also reduce stress concentrations, strengthening the plates.
Reply With Quote