View Single Post
  #5   Spotlight this post!  
Unread 13-07-2014, 18:31
immukage immukage is offline
Registered User
FTC #7767
 
Join Date: Dec 2013
Location: United States
Posts: 4
immukage is an unknown quantity at this point
Re: Brand New to CAD and PTC Creo

Thank you for all of the suggestions. We are trying a project based approach and just trying to get a feel for Creo, and then finding tutorials and such online.

On the FIRST section of PTC community/discussion page, are there specific tutorials for really learning the basics of the Creo/CAD? There were some tutorials, but they weren't too helpful in teaching tools and such.

Also, a quick question about using Creo itself, especially with the FTC Tetrix 2013 Kit of Parts. Sometimes, when I constraint things, they are only partially constrainted and I cannot find out how to fully constraint the last axis.

Also, more importantly, after you have fully constrainted a part (such as a c channel), and instead of being purple or orange, it is now its original color of gray, how do i edit the constraints, without deleting or undoing? Such as if the bar is angled a bit off, I want to reconstraint it to another hole, how would I do that after I already checked it?

Thanks again!
Reply With Quote