[wireties]

Originally Posted by sparkytwd

In 2013 3574 used a wiring system based on direct interface boards on the crio, 10 pin ribbon cable, and 8 breakout boards. The ribbon cable carried 8 digital io signals as well as power and ground. The wire-to-board headers were polarized and latch locked.

It's been over a year now, but it was explained to the judges and we were cleared to compete.

My project is very similar in concept (though I was not going to consolidate any signals). The connectors I plan to use are latching and polarized but use the same 0.025 square pins. Thanks for the pictures!