Thread: Custom RS550 Gearboxes
View Single Post
  #9   Spotlight this post!  
Unread 18-08-2014, 01:47
Rauhul Varma Rauhul Varma is offline
Drivetrain and Design Lead
FRC #0192 (GRT)
  
Join Date: Oct 2013
Rookie Year: 2012
Location: Palo Alto
Posts: 49
Rauhul Varma has much to be proud ofRauhul Varma has much to be proud ofRauhul Varma has much to be proud ofRauhul Varma has much to be proud ofRauhul Varma has much to be proud ofRauhul Varma has much to be proud ofRauhul Varma has much to be proud ofRauhul Varma has much to be proud ofRauhul Varma has much to be proud of
Re: Custom RS550 Gearboxes
Quote:
Originally Posted by Orion.DeYoe View Post
Where are the belts and pulleys sourced from? Gates? GT2 3mm wide?
The shaft for those motors is .125 inches if I remember correctly. Do the pulleys come with a bore this small? Do the bores have to be finished (reamed/drilled out)?
We buy our belts and pulleys from SDP-SI. The belt we used was a 9mm wide 3mm pitch GT2 belt. We had a bunch of 16T GT2 pulleys with 8mm bores as they were used in our drive gearbox, so we pressed in an insert that would reduce the bore to the correct diameter and then pressed the pulley with this insert onto the 775s. IIRC we just drilled the insert out to the correct diameter.