View Single Post
  #3   Spotlight this post!  
Unread 18-09-2014, 13:38
BSV BSV is offline
FTC / FRC mentor
AKA: Travis
FRC #2723
 
Join Date: May 2013
Rookie Year: 2011
Location: Oklahoma City
Posts: 148
BSV has much to be proud ofBSV has much to be proud ofBSV has much to be proud ofBSV has much to be proud ofBSV has much to be proud ofBSV has much to be proud ofBSV has much to be proud ofBSV has much to be proud ofBSV has much to be proud of
Re: [FTC]: FTC drive train CAD examples?

Quote:
Originally Posted by cadandcookies View Post
You're looking for the "Pin" constraint. When you're placing the part you want to be able to rotate, select it from the drop down menu.
Thanks - we found that one ("pin"), but no one could figure how what the second constraint that Creo was asking for should be. Then, when they got a second constraint to connect (not sure which one), it was not obvious how to test that it could move. Online videos show a gear (for example) just being grabbed with the mouse and it spins freely, but we were never able to duplicate that behavior.

We also looked at how to link two gears together, and think we figured that out (sort of), but haven't been able to test it due to not being able to make parts move.
Reply With Quote