View Single Post
  #1   Spotlight this post!  
Unread 19-09-2014, 18:11
BSV BSV is offline
FTC / FRC mentor
AKA: Travis
FRC #2723
 
Join Date: May 2013
Rookie Year: 2011
Location: Oklahoma City
Posts: 148
BSV has much to be proud ofBSV has much to be proud ofBSV has much to be proud ofBSV has much to be proud ofBSV has much to be proud ofBSV has much to be proud ofBSV has much to be proud ofBSV has much to be proud ofBSV has much to be proud of
Re: [FTC]: FTC drive train CAD examples?

Quote:
Originally Posted by MattRain View Post
When I build at least, I create my frame of the robot and what-not. When I want to get into the wheels and gears, I do the following. From there I take a gear, and I set it to Pin, and align the hole of the frame and the centered gear and the face of which I want touching/facing the frame. From there I build off the gear, i.e. wheels, axles, collars. If you set your gear to pin when first placing it, it should only move the gear, and whatever has been "attached" to the gear when you hold alt and ctrl.
OK, here is my sequence:

I load a C-channel piece.
I load a gear.
I select "pin".
I click on the center of the gear, then the center of one of the C-channel holes.
It lines up, says "coincident" on the middle of the gear.
Status at the top says: "connection definition is incomplete"

Where do I go from here? If I switch back to "user defined", it lets me click the green checkmark and says "partially constrained", but the gear will not spin around the axis.

Thanks for your help. Sorry I am so dense.
Reply With Quote