View Single Post
  #14   Spotlight this post!  
Unread 07-10-2014, 16:39
Oblarg Oblarg is offline
Registered User
AKA: Eli Barnett
FRC #0449 (The Blair Robot Project)
Team Role: Mentor
 
Join Date: Mar 2009
Rookie Year: 2008
Location: Philadelphia, PA
Posts: 1,109
Oblarg has a reputation beyond reputeOblarg has a reputation beyond reputeOblarg has a reputation beyond reputeOblarg has a reputation beyond reputeOblarg has a reputation beyond reputeOblarg has a reputation beyond reputeOblarg has a reputation beyond reputeOblarg has a reputation beyond reputeOblarg has a reputation beyond reputeOblarg has a reputation beyond reputeOblarg has a reputation beyond repute
Re: paper: Belt Driven VersaChassis WCD - Step by Step guide

449 ran 9mm belts last year without any issue on their WCD.

Looking at the belt specs (which are conservative - you can get more than the rated torque out of them given how short the lifespan is in FRC compared to industrial applications), if I were running an 8WD I'd probably be happier with 15mm between the two lower wheels. For a 6WD, where the vast majority of the robot's weight is on the center wheel to begin with, I don't think it's a likely problem.

As for why bother with 9mm, it allows one to use the WCP gearboxes with pulleys-in-gearbox just as one would do with chain. Personally, I'm not a huge fan of that setup - if a belt does break (admittedly unlikely but it's better not to tempt Murphy if you can avoid it) it's a royal pain to fix - but even in other setups it's nice and much more compact to be able to fit 2 9mm belts on one pulley than have two pulleys.
__________________
"Mmmmm, chain grease and aluminum shavings..."
"The breakfast of champions!"

Member, FRC Team 449: 2007-2010
Drive Mechanics Lead, FRC Team 449: 2009-2010
Alumnus/Technical Mentor, FRC Team 449: 2010-Present
Lead Technical Mentor, FRC Team 4464: 2012-2015
Technical Mentor, FRC Team 5830: 2015-2016

Last edited by Oblarg : 07-10-2014 at 16:44.
Reply With Quote