Quote:
Originally Posted by AdamHeard
What didn't work out well on the framing for bumpers on this?
|
Quote:
Originally Posted by Infinity2718
By the end of the season the bumpers were all smashed in at the top from no framing support and became more difficult to install, that's my beef with it.
|
Quote:
Originally Posted by AdamHeard
Hard to tell from just a top down picture, but assuming the supports between the wheels were at the correct height to support the bottom of the bumpers this should've worked out decent.
Was it a mounting issue? Did they have too much slop/play? Was it a once piece bumper?
Were you happy with the drive otherwise, and are just trying to solve the bumper issue?
|
The mounting could have been better, we used wing nuts with bolts through the bumper. It was a one piece bumper.
I have a handful of minor complaints: center live axle getting bent and wobbly a few times (took a while to replace, the dead axles performed better imo), bearing block plates hard to get at to loosen, gear box cantilevering off a few bolts seemed sloppy (, tensioners added construction and wheel maintenance time, if we got tipped the drive would sit on its frame edge and lose traction. Other than that and other things noted in this thread, it was pretty sexy.