View Single Post
  #24   Spotlight this post!  
Unread 03-11-2014, 10:28
nathannfm's Avatar
nathannfm nathannfm is offline
Registered User
AKA: Nathan
FRC #3940
Team Role: Mentor
 
Join Date: Jun 2010
Rookie Year: 2005
Location: Kokomo, IN
Posts: 331
nathannfm has a brilliant futurenathannfm has a brilliant futurenathannfm has a brilliant futurenathannfm has a brilliant futurenathannfm has a brilliant futurenathannfm has a brilliant futurenathannfm has a brilliant futurenathannfm has a brilliant futurenathannfm has a brilliant futurenathannfm has a brilliant futurenathannfm has a brilliant future
Re: Introducing Revolution Pro...crab/swerve module

Quote:
Originally Posted by ajlapp View Post
Thank you so much for this, I took a cross section and noticed there is a 1/2"id bearing right above the vertical bevel gear that doesn't seem to be doing anything. If it were 3/8 it would be guiding the shaft which would make sense, am I missing something? I also noticed there are no thrust bearings anywere, only thrust bushings, I guess you have found this to be acceptable?

Also, in the prototype with the hex shaft sticking out the top how did you manage to assemble that without using larger diameter hex bearings and thus a larger overall diameter?
__________________

[2016-20??]: Mentor: FRC Team 3940"CyberTooth"
[2013-2016]: Mentor: FRC Team 365 "MOE"
[2012-2013]: Mentor: FRC Team 3929 "Atomic Dragons"
[2011-2012]: Mentor: FRC Team 365 "MOE"
[2008-2011]: Student: FRC Team 365 "MOE"
[2007-2008]: Student: FTC Team 365 "MOE"
[2005-2007]: Student: FLL Team "The MOEstangs"
Reply With Quote