|
Re: New Electronics System Diagram
Why run the CAN bus with the PCM at the end? That means you have to manually include a terminator resistor, AND remember to move the jumper on the PDP to remove the built-in resistor there. The recommended path is to terminate at the PDP and have the PCM and any speed controllers in the middle.
__________________
2007 - Present: Mentor, 2177 The Robettes
LRI: North Star 2012-2016; Lake Superior 2013-2014; MN State Tournament 2013-2014, 2016; Galileo 2016; Iowa 2017
2015: North Star Regional Volunteer of the Year
2016: Lake Superior WFFA
|