Thread: How to use FTC hi-tech motor controllor on FRC
View Single Post
  #13   Spotlight this post!  
Unread 12-11-2014, 20:55
jhersh jhersh is offline
National Instruments
AKA: Joe Hershberger
FRC #2468 (Appreciate)
Team Role: Mentor
  
Join Date: May 2008
Rookie Year: 1997
Location: Austin, TX
Posts: 1,006
jhersh has a reputation beyond reputejhersh has a reputation beyond reputejhersh has a reputation beyond reputejhersh has a reputation beyond reputejhersh has a reputation beyond reputejhersh has a reputation beyond reputejhersh has a reputation beyond reputejhersh has a reputation beyond reputejhersh has a reputation beyond reputejhersh has a reputation beyond reputejhersh has a reputation beyond repute
Re: How to use FTC hi-tech motor controllor on FRC
Make sure you are enabling "Compatibility Mode" on the cRIO's I2C API. This enables clock stretching. Also, note that the addresses that the cRIO I2C API takes is an 8-bit address, not a 7-bit address. That means if you use address "3" on your arduio, you will need to use address "6" on the cRIO.