View Single Post
  #7   Spotlight this post!  
Unread 23-11-2014, 15:48
asid61's Avatar
asid61 asid61 is offline
Registered User
AKA: Anand Rajamani
FRC #0115 (MVRT)
Team Role: Mechanical
 
Join Date: Jan 2014
Rookie Year: 2013
Location: Cupertino, CA
Posts: 2,215
asid61 has a reputation beyond reputeasid61 has a reputation beyond reputeasid61 has a reputation beyond reputeasid61 has a reputation beyond reputeasid61 has a reputation beyond reputeasid61 has a reputation beyond reputeasid61 has a reputation beyond reputeasid61 has a reputation beyond reputeasid61 has a reputation beyond reputeasid61 has a reputation beyond reputeasid61 has a reputation beyond repute
Re: One tool/machine to level up a moderate shop

Quote:
Originally Posted by DonRotolo View Post
Yes, you can do light and limited milling with a lathe, using an attachment like the one shown on this page. For newer "non-collectable" lathes you can get one for under $150, but for old Atlas lathes I've seen these for $400+. Of course, you're not making sideplates with this, but most milling tasks are possible, albeit a little more time-consuming (you have to go slow).

An alternative is an X-Y milling vise for your drill press. You can do light milling with somewhat more flexibility than the lathe setup. Avoid the very cheap ones, they are terribly inaccurate. These are great for drilling accurate hole patterns as well (and often that's the only use they see).

Fair warning: Even if your drill press is a huge industrial beefy monster, this WILL hurt the spindle bearings a little each time you use it, but perhaps this trade-off is acceptable. New bearings are not costly, and the repair is good for the kids to learn. But a drill press is not designed for side loading on the chuck, just know that.

Give yourself some time to find a good machine, maybe a whole year. Find a parent or local business willing to show you the basics (or the trade school option mentioned above). Buy the book "How to run a Lathe" - way old school (100 years ago!) but a treasure trove of excellent data and instruction. Ask here, there are many who would be tickled pink to help.
Good advice. However, I disagree about the X-Y table for the drill press. Drill presses are not designed AT ALL for milling. If/when the spindle bearings fail, then the whole thing becomes a massive safety hazard. This is not a substitute for a mill and should not be used as one or anything other than plastic.