View Single Post
  #1   Spotlight this post!  
Unread 24-11-2014, 16:07
Cory's Avatar
Cory Cory is offline
Registered User
AKA: Cory McBride
FRC #0254 (The Cheesy Poofs)
Team Role: Engineer
 
Join Date: May 2002
Rookie Year: 2001
Location: Redwood City, CA
Posts: 6,795
Cory has a reputation beyond reputeCory has a reputation beyond reputeCory has a reputation beyond reputeCory has a reputation beyond reputeCory has a reputation beyond reputeCory has a reputation beyond reputeCory has a reputation beyond reputeCory has a reputation beyond reputeCory has a reputation beyond reputeCory has a reputation beyond reputeCory has a reputation beyond repute
Send a message via AIM to Cory
Re: One tool/machine to level up a moderate shop

Quote:
Originally Posted by Oblarg View Post
A drill chuck isn't nearly as precise as a collet - seems possible to me that it might not gain you much. As we don't have an edge-finder (since we don't have a mill), I'm just looking to know if it'd be a worthwhile purchase if we were to pursue this.
Any non-garbage drill chuck should have minimal runout. We will use an edgefinger in a drill chuck on our manual mill.
__________________
2001-2004: Team 100
2006-Present: Team 254