Quote:
Originally Posted by Arpan
Have you considered trying to make the Cims or shafts removable to facilitate easy gearbox removal?
|
Quote:
Originally Posted by Bryce2471
The Cims are already removable. (although not very easily)
|
It looks like one CIM mounting bolt on each CIM is blocked by the gears, and that this problem could be solved by slightly rotating the CIMs but this might just be becuase of the angle of the render.
Quote:
Originally Posted by Bryce2471
I don't see how the top motor is mounted less securely than the top motor of the WCP 3 CIM DS gearbox.
|
In yours there is much less webbing at the edges of the CIMs. Particularly the top one where there it is best to have webbing near the bottom of said CIM as this will prevent the CIM from sagging. I would recommend adding a web between the top standoffs on the back plate which would cross over the lower face of the top CIM.