View Single Post
  #2   Spotlight this post!  
Unread 07-12-2014, 22:44
Jay Clayton's Avatar
Jay Clayton Jay Clayton is offline
Registered User
FTC #7060
Team Role: Mentor
 
Join Date: Oct 2013
Rookie Year: 2013
Location: Pittsburgh PA
Posts: 2
Jay Clayton is an unknown quantity at this point
Unhappy Re: [FTC]: Encoders on new Andymark motors.

Team #7060 Fried Fuzes , would like to know if anyone using the NeveRest encoder cable, black end will not fit in the Motor Controller. With some trimming of the black plastic it will fit. BUT what is the proper direction in the MC ? Can anyone tell us what are the pin colors of the encoder port ? Yellow pin on the inside or outside , black end goes in MC both ways .

Thanx , Confused and Frustrated #7060
Reply With Quote