Thread: Flush-mounting rivnuts
View Single Post
  #2   Spotlight this post!  
Unread 13-12-2014, 20:24
Teched3 Teched3 is offline
Hodge1
FRC #0175 (BuzzRobotics)
Team Role: Mentor
  
Join Date: Apr 2006
Rookie Year: 1996
Location: Connecticut
Posts: 319
Teched3 has much to be proud ofTeched3 has much to be proud ofTeched3 has much to be proud ofTeched3 has much to be proud ofTeched3 has much to be proud ofTeched3 has much to be proud ofTeched3 has much to be proud ofTeched3 has much to be proud ofTeched3 has much to be proud of
Smile Re: Flush-mounting rivnuts
You could counterbore with an end mill. There is a style rivet nut that is knurled to "lock" it into the mounting hole, which make them a lot less prone to spin, making it difficult to remove.
__________________
Sweat the details
Why is there never enough time to do it right, but always enough time to do it again!
Even if you're on the right track, if you sit still, you'll get run over!!!