Quote:
Originally Posted by tim-tim
Just a habit of working on aircraft. The robots are vibration machines, so any little advantage to screws backing-out I will take. We have quite a few fastener stores in the area, so access to fine thread fasteners is not an issue.
That being said, we haven't used a 1/4" fastener on the robot in quite sometime - maybe a COTS component that required. We have used #10 rivet nuts in 1/4" holes in the past in the KOP frames.
|
I have found that Nylock nuts and bolts do not vibrate loose in FRC applications and if there is a situation where a Nylock is not suitable then we use medium strength thread locker. Once I introduced thread locker to the team there have not been any instances were a fastener came loose.
Where to you find rivet nuts that go in a 1/4" hole all the ones I've ever found use the annoying 19/64" bit. Because it is a less than common size we keep it in the kit with the rivet nuts so it is there when we need it.