View Single Post
  #25   Spotlight this post!  
Unread 22-12-2014, 16:52
JorgeReyes JorgeReyes is offline
Team Captain
FRC #2002 (Tualatin Robotics)
 
Join Date: Jun 2014
Rookie Year: 2006
Location: United States
Posts: 94
JorgeReyes is an unknown quantity at this point
Re: pic: Low Profile Gearbox Front View

Does anyone know if its possible to use this with the WCP gearbox bearing block ( which is currently shown on this gearbox) and using Versablocks on the sides. In the versa blocks, the 1/8" drop is created by flipping the block around.

http://content.vexrobotics.com/vexpr...40122-Rev2.PDF

Based of the drawing, I am thinking I could make the center of the gearbox bearing block .940" from the bottom of the 2in tube and then use versablocks on the sides. Would this work?
Reply With Quote