Quote:
Originally Posted by pribusin
Where to start ... Here are a few tips for startes: - Label your wires
- Keep power & motor cables short
- Use proper gauge wires for rated circuits (consult FRC manual)
- Label your wires
- Use proper wire strippers when removing insulation so as not to remove wire strands
- twist wire strands before inserting them into the PDB cage clamp terminals (prevents whiskers trom touching other circuits)
- Did I mention to label your wires?
- Route wires in a logical fashion and tie them down with zip ties
- Don't run power wires and PWM cables in one wire bundle
|
Two more things -- use a proper (ratcheting for larger than ~14ga) crimp tool, and label your wires!