News since last thread:
-After several requests, a 20 set kit is now being offered.
$60 MSRP, now available on site.
http://t811modulus.com/order/
-"Why is the center a 1/4x20 bolt? That's overkill." Cells now are predrilled for #10 bolts. This still works for a peg board, but alignment takes slightly more care. If you prefer the larger bolt, simply drill the hole out larger.
-"How much does it weigh?"
a kit of 30 sets= 2.65 lbs
a kit of 20 sets= 1.85 lbs
-"Looks like you can fit 2 new motor controllers on a mount"
You can! CAD available for adapter plates will be released later this week.
-Still not sure how you feel about it? Two of the Ri3D teams will be using the T811 and will give their feedback
-The manual is being revised. It will be available for kickoff and will be designed for time efficiency.
-Early parts may be green or black. This was due to plastic availability during the first run. All others will be natural ABS, which is paint friendly.