Thread: Configuring the CAN bus devices.
View Single Post
  #1   Spotlight this post!  
Unread 03-01-2015, 22:03
JohnGaby JohnGaby is offline
Registered User
FRC #2102
  
Join Date: Jan 2014
Location: Encinitas
Posts: 24
JohnGaby is an unknown quantity at this point
Configuring the CAN bus devices.
How do we discover/configure the addresses of the CAN bus devices for the new control system. In the past, we have used the BDC-COMM utility to configure the CAM address of our Jaguars via a serial port, but it is not clear if/how this might be used with the new system. Is there CAN configuration utility for the new system. Are the new CAN devices (e.g. the power distribution board) at known addresses, and, if so, where can we find those addresses?

Thanks.
Reply With Quote