[inventor_phild]

Based on the comments about the size of the tote I contacted the company who provided the 3D model to the software vendors that support FIRST teams.

1. Their intent was to provide a representative 3D model. For example, the lid is not comprised of a hinge assembly, and that there are a few rounds missing here and there. There are also no zip-ties or holes to zip-tie the lids closed. This should not impact your simulations.

2. They agree that the 3D model is smaller than the actual tote and it is important to correct the dimensions. The base of the tote appears to be correct with the upper lip being the issue.

3. They did not include the dividers as per comment 1.

4. They have provided me with updated STEP files and I will make those available on A360 Drive by tomorrow morning.

Thanks for the feedback from the folks that spotted this issue.