Quote:
Originally Posted by joeyoravec
According to the manual it's "not receiving power" which is untrue. I think it's broken. Just sent an email to CTE tech support, and watching this thread.
|
Thanks, please let us know what they say, I'll contact them too to document the failure. This was the case from the very first power up for our unit.
I just checked and the PDPs are out of stock, and we only have one. Ours is bad out of the box I believe. Hopefully the fix will just be firmware.
Pertaining to the inspection requirement for functioning CAN on the PDP, if you can't buy them and they are bad out of the box, what can you do...? I'm assuming they'll replace faulty units and get back in stock during the build season, but if not that would be a show stopper.