Hey guys, I'm getting a similar error. it makes it to the end and then sends a message:
Code:
"Bridge configuration failed: IP address not restored to DHCP
please ensure the bridge is connected to this computer and try again
I've gotten this same error message on three different D-Links(two Rev-B and one Rev-A), and two laptops (both Windows-7 64-bit). The d-link is most definitely connected to the computer. Also, when I followed the manual set-up instructions to finally get it working in
this thread (last post) it worked for one meeting
then the next it didn't! I could ping the roboRIO, but the driver station wouldn't connect to it, and yes the Driver Station is v15.0. I've reset the bridge and tested it multiple times, turned off windows firewall (mcAfee isn't installed), turned off the wireless network adapter, and it still gives that same error when I try to image it. I've run it in compatibility mode also, and still the
exact same error.