Thread: CANJaguar errors on driver station after deploying code
View Single Post
  #5   Spotlight this post!  
Unread 17-01-2015, 12:50
RufflesRidge RufflesRidge is offline
Registered User
no team
  
Join Date: Jan 2012
Location: USA
Posts: 989
RufflesRidge has a brilliant futureRufflesRidge has a brilliant futureRufflesRidge has a brilliant futureRufflesRidge has a brilliant futureRufflesRidge has a brilliant futureRufflesRidge has a brilliant futureRufflesRidge has a brilliant futureRufflesRidge has a brilliant futureRufflesRidge has a brilliant futureRufflesRidge has a brilliant futureRufflesRidge has a brilliant future
Re: CANJaguar errors on driver station after deploying code
Quote:
Originally Posted by Tyler Scheuble View Post
I am having problems finding out where to get that. Does this screenshot make sense for you?
http://puu.sh/eEcav/f85f6c8588.png
It does and it indicates that your roboRIO sees no devices on the CAN bus (or you took it shortly after boot-up and you need to refresh the page).

Check your CAN wiring (I would try taking the Jags out of the chain and wiring from roboRIO to PCM if used) to PDP and see if you can get at least one device to show up, then start adding Jags to see where the cabling issue is.
Reply With Quote