Thread: Configuring the CAN bus devices.
View Single Post
  #11   Spotlight this post!  
Unread 17-01-2015, 19:10
controls weenie's Avatar
controls weenie controls weenie is offline
Registered User
FRC #2973
Team Role: Mentor
  
Join Date: Oct 2014
Rookie Year: 2011
Location: United States
Posts: 23
controls weenie is an unknown quantity at this point
Re: Configuring the CAN bus devices.
We connected the solenoid, compressor and air valve switch (sensor) to the PCM. We are now trying to control the 24V solenoid using LabVIEW. Our PCM CAN bus address is 0. We set the jumper to 24V.

How do we control the solenoid in LabVIEW? The Solenoid vi takes the CAN bus ID (0 in our case) but we need to send it a message somehow. Where is this documented? There are 8 solenoid outputs.

Thanks
Reply With Quote