Quote:
Originally Posted by Pendulum^-1
http://www.polybelt.com/clamingp.php
Google timing belt clamping plates.
We plan to use a long timing belt length, clamping each end to the carriage, adjusting clamp location and belt length for coarse belt tension, and possibly an idler for fine adjustments, as needed.
|
Jim,
Have you actually used/seen the clamps for HTD belt from polybelt? I see the picture they show on the item details page for HTD clamps doesn't have the round tooth profile. I didn't know if their pic just wasn't representative OR if they consider clamping round-tooth belts with a squareish-tooth clamp to be OK.
Thanks though for the link. This place is about 4x cheaper that anything we found just yesterday for these.