|
Re: 3d printed talon mounts
Quote:
Originally Posted by dellagd
Why not make it double sided for the ability to mount 4 at once? I don't think it would be too difficult to make the design such that it can be structurally sound but also accommodate talons on each side.
|
The diagonal of the screw holes makes it so they can not be mirrored in this way, although if one talon is turned 90 degrees the holes are separated far enough for them to be mounted front and back.
__________________
2015: Galileo Semifinalists
2015: North Star Regional Finalists (Thanks to 5576 and 2531)
2014: North Star Semifinalist (Thanks to 2175 & 4607)...again
2014: Central illinois Semifinalist (Thanks to 1756 & 1288)
2013: North Star regional Winner (Thanks to 2175 & 4607)
2013: Curie Semifinalist (Thanks to 2056 & 3990)
2013: IRI Semifinalist (Thanks to 359, 1477, & 148)
|