So maybe a block of rubber with holes punched into it would work?
Quote:
Originally Posted by emmell
Maybe how about using two LEGO motors (ports B and C) as they try to naturally sync when you apply the same power to them (PID control kept by the NXT). If you're using ROBOTC, I think they keep it that way as well in the firmware as does the LabVIEW version does.
|
We thought about this but the cables to the motors would be required to be longer than the maximum allowed cable length, plus probably not enough torque. The loader is out at the end of an arm that is attached to a linear lift.
We'll run some tests on the servos when they come in. May have to improvise a little.
Thanks!