Thread: Anyone heard more about the Ekocycle 3D printer?
View Single Post
  #13   Spotlight this post!  
Unread 20-01-2015, 17:14
rockychat3 rockychat3 is offline
Registered User
FRC #4859
  
Join Date: Dec 2014
Location: Byron, MN
Posts: 5
rockychat3 is an unknown quantity at this point
Re: Anyone heard more about the Ekocycle 3D printer?
Is it possible to use any PET as long as you load it into their special cartridges? The printer is super cool but I'm terrified to use up the included spools at $50/each!

Example: http://www.amazon.com/MadeSolid-PET-.../dp/B00PH4D5P6
Reply With Quote