Thread: Anyone heard more about the Ekocycle 3D printer?
View Single Post
  #13   Spotlight this post!  
Unread 20-01-2015, 17:22
mman1506's Avatar
mman1506 mman1506 is offline
Focusing on Combat Robots!
AKA: Marcus Quintilian
no team (WARP7)
Team Role: Alumni
  
Join Date: Mar 2012
Rookie Year: 2012
Location: Toronto
Posts: 802
mman1506 has a reputation beyond reputemman1506 has a reputation beyond reputemman1506 has a reputation beyond reputemman1506 has a reputation beyond reputemman1506 has a reputation beyond reputemman1506 has a reputation beyond reputemman1506 has a reputation beyond reputemman1506 has a reputation beyond reputemman1506 has a reputation beyond reputemman1506 has a reputation beyond reputemman1506 has a reputation beyond repute
Re: Anyone heard more about the Ekocycle 3D printer?
Quote:
Originally Posted by rockychat3 View Post
Is it possible to use any PET as long as you load it into their special cartridges? The printer is super cool but I'm terrified to use up the included spools at $50/each!

Example: http://www.amazon.com/MadeSolid-PET-.../dp/B00PH4D5P6
Nope, the cartridges contain a chip that stores filament type and length remaining. As filament is extruded the printer updates the length remaining value on the chip. When that value hits zero the printer will refuse to print even if filament is available.
__________________
2014-2015: FRC 865 Warp7 Team Captain
2016: FRC 865 Mentor
2017: Free Agent Mentor, Inspector
Reply With Quote